6 Meters Grain Suction Hose Machine Wheat Grain Suction Machine Wheat Corn Auger Screw Feeding Machine

1. When starting up, the motor drives the dragon in the pipe to rotate at high speed. The pipe will shake violently when it is started for the first time. This is normal for the first time, so pay attention to safety.

2. When using, avoid collision with hard objects and wear the pipe. The bending radius of the hose cannot be less than 130° and cannot form a 90-degree right angle. It cannot be bent to prevent the pipe from being worn out. The straighter the pipe, the longer the service life of the hose. long

3. The discharge port (machine head) cannot be bent at 1-1.5 meters and must be kept balanced.

4. Do not add wet ingredients

5. Try not to idle the machine for a long time to prevent the pipe from being worn out.

6. If you feel that the feeding is slow, you can shorten the tube appropriately to increase the feeding speed.

7. If material blockage occurs during the operation of the machine, it should be stopped immediately. The material in the pipe must be cleared out before it can be restarted.

8. If the blade is artificially damaged during use, it can be welded with a welder. When welding, the two blades are screwed in twice first and then welded.

9. Material blockage or motor reversal can easily cause the blades to twist into twists. After twisting the twist, cut off the twisted section (usually 0.5--1 meter). Cut the pipe into an appropriate section, re-tighten it and install it before you can continue to use it.

10. When starting up the machine for the first time, the pipe needs to be adjusted to a straight state, and the new machine needs to be run-in. Therefore, a small amount of material must be fed with a shovel for the first time. After the outlet starts discharging material, work for 5-10 minutes, and then a large amount of material can be fed normally. During daily work, the machine should be turned on first and then fed. There should be no grain in the pipeline every time it is turned off and started.

11. When starting up a new machine, staff should stay away from the machine to avoid touching it.